The display shows which program is running and, alternating, the
speed or the remaining time of this program.
The shaker can be stopped at any time by pressing the OK key.
Press the OK key again to restart the shaker.
The stored values and the program flow remain stored also after
the shaker is switched off. If the shaker is operated in a different
mode, the values of mode C remain stored.
Switch the device on and press the OK key to restart the shaker.
To change or delete the program flow, press the key
▲
or
▼
until
„Rem“
appears
on
the
display.
With the OK key the programs are deleted from left to right.
=
=
✴
flashes
✴
flashes
Rem
STOP
32--
P5
532
150
4.3 Changing the motion
Multi-Purpose Shaker KL 2
The motion can be changed by means of the coupling lever at the right side:
The coupling lever must audibly snap into its final position.
- Pull out coupling lever
->
orbital motion
- Push in coupling lever
->
to-and-fro motion
ATTENTION:
Change the motion only when the device is running
with
minimum
speed!
Changing the shaking motion at high speed can cause
damages
to
the
device.
Universal shaker SM 30
The motion can be changed by actuating the lever at the front of the shaking plate:
−
Move the shaking plate forward by hand until the right front edge of the
shaking plate corresponds with the mark on the housing.
−
Loosen the star-shaped knob at the front of the shaking plate.
−
Move knob to the far left position => to-and-fro motion
−
Move knob to the far right position => orbital motion
−
After having chosen the motion, tighten the star-shaped knob again.
Edmund Bühler GmbH ALLGEM\BED.SMG/BEDSME/TXTE.DOC – 01/08
16
