
Español
Italiano
Français
Deutsch
English
9
Names of Things and What They Do
6. Three-D Y/C separation button [3D Y/C]
This is available only in NTSC mode (p. 11). This will reduce certain problems that may
occur when a composite signal is being input, such as fine diagonal black and white stripes
producing a rainbow-like effect (cross color) or the appearance of small white and black dots
outlined in black (dot interference), and will clean up the signal by reducing color smearing.
Normally, you should leave this on. If there is a great deal of movement in the image, this
may cause blurring. If so, turn this off. If this is off, 2-D Y/C separation is applied.
* In PAL mode 2-D Y/C separation is always applied, so this button will be disabled.
7. Automatic brightness adjustment button [AGC]
This corrects the over-exposed whites or under-exposed blacks that can occur if the
brightness of the image is not appropriate. Normally, you should leave this on.
* Correction is not possible if the input video already has over-exposed whites or under-exposed blacks.
8. Audio level indicator
The green indicator will light when an analog audio signal is input. The red indicator will
light if the input level is excessive. Lower the audio input level until the red indicator does
not light.
9. Power button [POWER]
10. Brightness knob [BRIGHT]
Turn this knob toward the right to brighten the image, or toward the left to darken the
image.
11. Color depth knob [COLOR]
Turn this knob toward the right to deepen the color, or toward the left to lighten the color.
12. Color hue knob [HUE]
Turn this knob toward the right to give the image a more greenish hue, or toward the left to
give it a more purple hue.
13. Contrast knob [CONTRAST]
Turn this knob toward the right to make the contrast stronger, or toward the left to decrease
it.
14. Audio input level knob [AUDIO LEVEL]
Turn this knob toward the right to increase the audio input level.
* When a DV signal is input, buttons/knobs/indicators 4.–8. and 10.–14. are disabled. These functions
apply only to analog input signals.
* When a DV signal is input, the indicators of each button and the illumination around the knobs will
go out.
VMC-1(A5)_e.book 9 ページ 2005年11月14日 月曜日 午後2時51分