23
Using the R-09
Recording with the [Internal MIC].
When using the [Internal MIC], do not connect anything to the [MIC Input Jack] or [LINE IN Jack]. If a
microphone or cable is connected to the [MIC Input Jack] or [LINE IN Jack], input from these jacks take
precedence, and input from the [Internal MIC] is disabled.
1.
Adjust the input level.
fig.rec-st-e.eps_80
1. Enter the recording-standby mode.
Press the [REC Button] while the <Main Screen> is
showing. The [REC Indicator] blinks. The unit is in
recording-standby mode.
fig.inputlevel-test.eps_80
2. Play the song to record into the microphone.
The level meter indicates the loudness of the input to R-09.
fig.inputlevel-set.eps_80
3. While the sound is being output, press the [(+) (-)
Input Level Button] to adjust the volume gradually.
Adjust so that the level meter moves as far to the right as
possible without the [PEAK Indicator] turning on.
If the [PEAK Indicator] stays lit, then the input level is too
high, and the recorded sound becomes distorted.
See “Adjusting recording levels” (p. 37) for details on adjusting
the input level.
fig.rec-start-e.eps_80
2.
Press the [REC Button] to begin recording.
The [REC Indicator] lights up.
fig.rec-stop-e.eps_80
3.
Press the [STOP Button
] to stop
recording.
The [REC Indicator] goes out, and the recorded song is
shown in the display.
Power cannot be turned off during recording.
See “Configuring recording” (p. 26) for details on recording
settings.
Recording
Recording
standby
Starts
recording
Stops
recording
R-09_e.book 23 ページ ２００７年２月１３日 火曜日 午後３時２７分
