VERIS
™
Service Manual
EMS & FMS Stimulators
VG-119-D / 21-Jan-2017
Page 9 of 16
Adjust the articulating arm so that it freely floats the stimulator for easy positioning.
Hold adjustments can be used
to prevent unwanted arm
movements. Wrenches for the
adjustments are included with
the arm.
Connect the cables
IMPORTANT: Observe the keyed orientation of the black LVDS connector to the Controller.
Use the included DVI-to-Thunderbolt adapter to connect the DVI cable to a computer with
Thunderbolt ports.
Connect the gray 5-pin Cable 31-02 (blue dot) from the rear of the FMS Control Box to the DIN
connector (blue dot) at the upper left corner of the Switchbox labeled "FMS Power Out".
The GearMo serial adapter connects directly to the control box serial port and to the serial port of the
Grass 15LT amplifier.
If replacing a previously installed Keyspan Adapter, it will be necessary
to install the GearMo driver.
Connect the VGA connector of the long grey cable (FMSIV-Cable-76) to the matching connector on
the back of the black display tube of the FMS IV. The other end is connected to the VGA connector
of the switchbox.
Older switchboxes that lack a VGA port require a Cable 76 having a DIN
connector and RCA plug in place of one VGA connector. Call EDI for assistance in this
situation.
Switchbox
FMS
Controller
FMS IV
or
EMS IV
Serial
Adapter
Computer
USB port
LVDS
Cable 76
DVI
Cable 31
Thunderbolt port
FMS / EMS IV Block Schematic
Hold adjustments
Small wrench
Stimulator Arm Adjustments
Large wrench
