EdgeMarc 4576 Enterprise Session Border Controller Installation Guide
5
Back Panel
LED Label
Description
A
Power Connector
Accepts the plug from the supplied power cord to connect the unit
to an AC power outlet.
B
Power Switch
Turns the system power on or off.
E
10/100 Mbps
Ethernet
WAN Port
This port is typically used when connecting the EdgeMarc 4576 to an existing
WAN router, cable or xDSL modem. This is an auto-sensing, RJ-45 port
which supports half or full duplex mode.
F
USB Ports
2 (Version 2.0) x USB ports can be used for EVDO WAN connections and
maintenance functions.
G
Console Port
This port is used to establish a local console session with the EdgeMarc
4576 using a VT100 terminal or emulation program. The cable required is a
Male to Female straight-through DB-9 cable. The serial port uses a baud rate
of 9600, 8 data bits, 1 stop bit and no parity.
This port is used for debug or local diagnostic purposes only. Primary
configuration of the EdgeMarc 4576 is performed from a web browser as
covered in
Edgewater Networks
VoIP Operating System (VOS) for EdgeMarc
User Manual.
H
Phone Status
Indicator
Off
No active call
Green
Active call
I
Phone
24 FXS ports for connecting analog and key system phones to the network.
Requires a male 50-pin Amphenol type connector (90 degree or 180 degree).
Not included.
