Edgewater Networks 190 InShore 2014 Series, Owner Assistance Manual

Page: 13 / 214

11
Instrument Maintenance
Your instrument faces should be periodically cleaned to keep them free of salt and atmospheric
debris. The ignition switches should be periodically sprayed with a contact cleaner/lubricant to
keep them free of corrosion and dirt.
4/ Fuel System
4.1 General
All fuel systems and components on your EdgeWater 190IS have been checked and each fuel
tank has been pressure tested. This inspection and pressure testing assure that your fuel system
is leak proof and safe. It is the purchaser’s responsibility to maintain the fuel system in a safe
manner. Make periodic inspections to determine the system is still safe and free from leaks.
Special care should be taken when inspecting joints and connections to make sure they have not
loosened with vibration.
The EdgeWater fuel system has been designed to meet or exceed the requirements of the U.S.
Coast Guard, the National Marine Manufacturers Association, and the American Boat and Yacht
Council, which were in effect at the time of your boat’s manufacture.
If any odor of gasoline is detected, immediately shut off all engines and electrical devices
until the source and condition of the odor has been determined and eliminated. Have a
fire extinguisher at the ready until the condition has been resolved.
4.2 Fuel Fill
The fuel fill cap is located on the port side and is labeled “GAS”. The fill is opened by turning it
counterclockwise, and closed by turning the cap clockwise. Tighten the cap until it is snug, not so
tight it cannot be removed at the next fuel stop, or so tight that the rubber o-ring is damaged,
allowing water to enter the system.
4.3 Fuel Vent
This vent is located and incorporated into the fuel fill cap. This vent allows air to escape from the
tank and thus allows fuel to enter. Make sure this vent is kept free from debris.
4.4 Fueling
Your EdgeWater 190IS is equipped with a built-in 42 gallon fuel tank. Before fueling, you should
follow these procedures.
·
Make sure the boat is securely moored.
·
Make sure all switches are off and all cigarettes are extinguished.
·
Know the location of the fire extinguisher in case of an emergency.
·
Remove the fuel fill cap.