3-13
3.
The NET status in DISCOVER should change from NET OFF to NET ON, as shown in
Figure 3-9: NET: ON
4.
Next, you should run a Tap Test. To do this, navigation to the Sub-Bottom Control Tab, shown in
Figure 3-10: The Sub-Bottom Control Tab
5.
In the Shortcut Toolbar, set Gain to either 0 or -3 dB, and then click Normalize Gain Button.
CAUTION!
Do not allow the transducers on the tow vehicle to continuously transmit
in air for an extended period, as damage to the transducers could occur.
6.
In the Sub-Bottom Control Tab, select a Transmit Pulse using the “Pulse” drop down. Set “Transmit
Level (%)” to “0”. Select the “Transmit On” checkbox.
7.
The transducers on the tow vehicle should begin transmitting (at zero power) and receive data
should begin scrolling on the display in the DISCOVER Main window from right to left.
8.
Tap the underside of the tow vehicle near the hydrophones with the handle of a screw driver,
while observing the Waterfall Display in the DISCOVER window. Streaks or noise spikes should be
visible in the Waterfall Display, as shown in
This verifies the receive channel is
operating.
Summary of Contents for Model 3100P Sub-bottom Sonar System
