12
To Operate in Fan Mode:
Use this function only when cooling is not desired, such as for room circulation or to
exhaust air (remember to open the vent). You can choose any fan speed you prefer.
In Fan mode, the display will show the actual room temperature.
In Fan mode, you cannot adjust the set temperature.
Energy Saver Feature
Press the Energy Saver button to initiate this feature. This feature is available in Auto,
Cool or Dry modes.
In this mode, the fan will continue to run for three (3) minutes after the compressor
shuts off. The fan then cycles on for two (2) minutes, at ten (10) minute intervals, until
the room temperature is above the set temperature at which time the compressor turns
back on and cooling resumes.
The Fan Speed can be adjusted when using this feature.
Timer (Auto Start/Stop) Feature
To initiate the Auto Start program, press the Timer button when the unit is
off
.
To initiate the Auto Stop program, press the Timer button when the unit is
on
.
Press or hold the Left (Decrease) or Right (Increase) button to change the Auto Time by
½ hour increments up to 10 hours, and then one (1) hour increments up to 24 hours.
The selected time will register in five (5) seconds and the system will automatically
revert back to display the previous temperature setting or room temperature when the
unit is on.
Turning the unit on or off at any time or adjusting the timer setting to 0.0 will cancel the
Auto Start/Stop program.
Sleep Feature
Press the Sleep button to initiate this feature.
In this mode, the selected temperature will increase by 2°F (1°C) 30 minutes after the
feature is selected. The temperature will then increase by another 2°F (1°C) after an
additional 30 minutes.
This new temperature will be maintained for six (6) hours before it automatically returns
to the originally selected temperature. This ends the Sleep feature and the unit will
continue to operate as initially programmed.
The Sleep feature can be canceled at any time by pressing the Sleep button again.
The Sleep feature is only available in Auto or Cool modes.
Filter Check Feature
This feature is a reminder to clean the Air Filter for more efficient operation. The LED
light will illuminate after 250 hours of operation. To reset after cleaning the filter, press
the Filter Check button and the indicator light will turn off.
Note: When the unit is powered off, there is no display.
