7
Draining the Unit
There are 3 different ways in which this dehumidifier can be drained:
pump drain, manual drain and continuous gravity drain. Please review
the below descriptions and instructions for each method to determine
which is best for your specific setup.
This dehumidifier comes with the built in pump that will engage
automatically to drain water into a floor drain or other suitable drainage
port. To setup the dehumidifier to utilize the built in pump please follow
the instructions below.
1.
Locate the pump drain hose and insert firmly into pump drain
outlet on the lower left side of the back of the unit.
2.
The drain hose will click into place when attached properly.
3.
Place the other end of the drain hose in a floor drain or other
suitable drainage port.
4.
Operate unit in normal manner.
5.
To remove pump drain line, press the release button located
directly above the pump outlet.
NOTE: If the pump drain hose has not been connected properly, the
unit will not activate the pump feature. A sensor is located at the
pump drain hose connection to detect if the hose has been properly
connected. There will be an audible ‘click’ that can be heard when
inserted properly. Once connected properly, the dehumidifier will
automatically switch to using the drain pump.
Pump Drain
Note
: The pump will not be
activated if the water bucket is
full or not installed properly.
Please empty the water bucket
and re-install properly before
using the pump drain feature.
Note
: The pump is capable of
pumping water up to 16ft
vertically or horizontally.
