EdgeStar Combo Washer/Dryer
20
Cleaning the inlet filter
If supply valve is fully opened and there is an insufficient amount of water
coming through the hose you may need to clean the inlet filters. The inlet
filters are wire mesh screens located immediately inside the hot and cold
water line connections on the back of the unit. You will need a pair of
needle nose pliers to remove the filters for cleaning.
1.
Close the water valve(s) entirely.
2.
Select any procedure on Control K
nob and press the “Start/Pause”
button and let run for about 40 seconds. This will draw existing
water out of the supply lines and into the tub.
3.
Unscrew the supply hose(s) from the backside of the unit.
4.
Pull out the inlet filter(s) with needle nose pliers and wash under
warm water to remove any debris.
5.
Re-install inlet filter(s) and reconnect hose(s).
6.
Open the water valve(s) and ensure there is no water leakage.
Removing foreign objects from coin trap
The Coin Trap can collect small objects from the wash cycle. Clean out
the coin trap regularly to ensure normal operation of washing machine.
Please allow the unit to cool down sufficiently before opening the coin
trap knob as hot water may be present. The Coin trap door is located on
the front, bottom right hand side of the machine. Follow the below
instructions to clean out the coin trap:
Step 1:
Open coin trap door
by pressing release tab and
gently pulling door forward
Step 2:
Turn knob
counter-clockwise
Step 3:
Pull out coin trap
and remove items
Step 4:
Reinstall coin trap
knob and tighten firmly
IMPORTANT: A small amount
of water may be present in the
coin trap and will be released
when knob is opened. Please
have a towel and/or small
drain pan to catch any water.
WARNING: Hot water may be
present if machine has not
been allowed to cool down
sufficiently. Please allow unit
to cool down prior to removing
coin trap knob.
Note:
Use a drain pan or a towel to collect excess water
