13
Control Panel Details
The chart below provides details on each setting, button, and function available on the Control Panel. The numbers on the left correspond
with the number references from the Control Panel diagram on the previous page.
On / Off
- Press once to turn unit on and activate the display panel. If the display is active, press once to turn the display panel
off.
Start/Pause
- Press to start desired wash cycle. If the washer is running, pressing it once will pause the washer. Press again to
restart the wash cycle.
NOTE: If the washer is paused and the cycle is not restarted within 10 minutes, the current wash cycle will
be cancelled.
Control Knob
- Use the control knob to select the desired cycle. Refer to the Cycle Guide Chart for additional information.
Time Save
- Press to select the Time Save mode. Selecting Time Save will reduce the wash cycle time and will adjust the
estimated time shown on the control panel display. Refer to the Cycle Guide Chart for additional information.
Delay
- Press to adjust the timer delay in increments or 1 hour up to 24 hours. You may cancel the timer delay by adjusting the
hours back to 0. The Delay setting will be shown on the control panel display.
Temp.
- Press to select the desired water temperature level
–
Cold, Eco, Warm, Hot, Hot+. The Temp. setting will be shown on the
control panel display.
Spin Speed
- Press to select the desired spin speed level - No Spin, Low (600 rpm), Med (800 rpm), High (960 rpm) and Highest
(1120 rpm). The Spin Speed setting will be shown on the control panel display.
Soil Level
- Press to increase time for heavier soiled items. There are three soil levels, Light, Med and Heavy. The Soil Level setting
will be shown on the control panel display.
Dry Level
- Press to select the desired drying level - Less, Normal, More ( ). The Dry Level setting will be shown on the
control panel display.
Additional Control Panel Functions:
Sounds
: Pressing the Time Save and Delay buttons at the same time will turn on / off the sounds that are played during startup,
power down, and end of cycle. Please note that disabling sounds will also disable the sounds that are played when buttons are
pressed.
Child Lock
: The child lock can be activated by pressing the Soil and Dry Level buttons at the same time and holding for 3 seconds.
When engaged, the control panel becomes locked and no settings can be altered. The On/Off button remains active. If the unit is
turned off and back on while the Child Lock is engaged, the Child Lock must be turned off to restart the cycle. ** Note: If sounds are
turned on, the button sounds will be muted when the Child Lock is active.
My Cycle
: The My Cycle feature allows you to create and save a custom wash cycle (temperature, spin, soil etc) that can be easily
saved for future use. To save your customs settings as My Cycle, adjust the cycle settings according to your preference and press
and hold the Spin button for 3 seconds. To start a My Cycle wash, adjust the dial to My Cycle and press the Start/Pause button.
