Edge Technologies Minuteman 320 SE, Operation Manual

Page: 134 / 222

MINUTEMAN
320
127
REV 13.1:2020
F2 Fixed Parameter
Setting unit Range Suggested setup
Sec 0~10 0.5 sec
Description:
Setting method:
Note:
Delay after new bar reaches facing position before cycle start signal is
sent from bar feed to lathe.
Enter value required for delay.
The longer the set time the longer bar change will take
Setting unit Range Suggested setup
mm/In 0~999 Depend on actual position
Description:
Setting method:
Note:
The position in which the Moveable anti-vibration device will reclose
back on the pusher.
After setting the MAVD opening position, measure to when the Pusher
and rotating tip have passed entirely through the MAVD and then set it
as that distance.
If this parameter is set to 0 it will disable the MAVD from reclosing on
the pusher.
Setting unit Range Suggested setup
Sec 0~999 0.5sec
Description:
Setting method:
Note:
When barfeed is sending End of Bar signal to lathe, lathe goes to bar
change program, lathe collet will open, bar change signal is sent to
barfeed. Once barfeed receives the bar change signal the barfeed will
wait for value set then start bar change sequence)
Enter value required for delay.
If value is too long, pusher may start forward into lathe again.