Edge Technologies Minuteman 320 SE, Operation Manual

Page: 119 / 222

MINUTEMAN
320
112
REV 13.1:2020
7.0 Parameters and Programing
7.1 Programming
Caution only trained operators are to change part parameters.
Parameters can have a large impact on efficiency of the production process. A parameter value
could lead to longer than desired remnants to inability to run nonstop production. Understanding
the parameters and how to set them is important. Certain parameter screens are accessible only
with a password. If access to a password protected parameter is required and you don’t have
the password contact Edge Technologies and speak with our service department.
During the installation process certain parameters must be set in order for the bar feeder to
perform properly in the automatic mode. If the parameters are not set correctly production
problems are almost certainly guaranteed. The minuteman does not use a stored program
system. Anytime a part program change is required each parameter value will need to be
modified. Note normally parameters set during the installation process are normally not
adjusted. See parameters list in this manual.
Edge Technologies reserves the right to make programming modifications to the HMI and
PLC software. As of the printing of this manual the current software available is
represented with in this manual. Any deviations between this manual and your machine
is the result of software version difference. For additional information please contact
Edge Technologies Service Department.