Edge-Core ES4308-POE, Management Manual

Page: 19 / 52

Web Configuration
3-5
Web Configuration
Displaying Status Overview
You can easily identify the system by displaying the device name, location and
contact information.
Field Attributes
System Information
• System Name – Name assigned to the switch system.
• Number of Ports – Number of built-in ports.
• Hardware Version – Hardware version of the main board.
• Code Version – Version number of the code.
• Serial Number – The serial number of the switch.
Address Information
• Management VLAN – ID of a configured VLAN through which you can manage
the switch. By default, all ports on the switch are members of VLAN 1. However,
the management station can be attached to a port belonging to any VLAN, as long
as that VLAN has been assigned an IP address.
• IP Address – Address of the VLAN to which the management station is attached.
(Note that the management station must always be on VLAN 1. Valid IP
addresses consist of four decimal numbers, 0 to 255, separated by periods.
• Subnet Mask – This mask identifies the host address bits used for routing to
specific subnets. (Default: 255.255.255.0)
• Gateway IP Address – IP address of the gateway router between the switch and
management stations that exist on other network segments. (Default: 0.0.0.0)
• MAC Address – The physical layer address of the switch.
Port Information
• Type – Indicates the port type.
• Link Status – Indicates if the link is Up or Down.
• Speed/Duplex Status – Shows the current speed and duplex mode.
• 10hdx : 10 Mbps half duplex.
• 10fdx : 10 Mbps full duplex.
• 100hdx : 100 Mbps half duplex.
• 100fdx : 100 Mbps full duplex.
• 1000fdx : 1000 Mbps full duplex.
• Flow Control Status – Indicates whether flow control is enabled or disabled.
(IEEE 802.3x, or Back-Pressure)
• Autonegotiation – Shows if auto-negotiation is enabled or disabled.