Edge-Core ES3628C, Management Manual, Page: 589 / 674

IP Routing Commands
4-263
4
• For authentication to function properly, both the sending and receiving
interface must be configured with the same password.
Example
This example sets an authentication password of “small” to verify incoming routing
messages and to tag outgoing routing messages.
Related Commands
ip rip authentication mode (4-263)
ip rip authentication mode
This command specifies the type of authentication that can be used on an interface.
Note that the current firmware version only supports a simple password. Use the
no
form to restore the default value.
Syntax
ip rip authentication mode { text }
no ip rip authentication mode
text - Indicates that a simple password will be used.
Command Mode
Interface Configuration (VLAN)
Default Setting
No authentication
Command Usage
• The password to be used for authentication is specified in the ip rip
authentication key command (page 4-262).
• This command requires the interface to exchange routing information with
other routers based on an authorized password. (Note that this command only
applies to RIPv2.)
• For authentication to function properly, both the sending and receiving
interface must be configured with the same password or authentication key.
Example
This example sets the authentication mode to plain text.
Related Commands
ip rip authentication key (4-262)
Console(config)#interface vlan 1
Console(config-if)#ip rip authentication key small
Console(config-if)#
Console(config)#interface vlan 1
Console(config-if)#ip rip authentication mode text
Console(config-if)#