Edge-Core ES3628C, Management Manual, Page: 355 / 674

System Management Commands
4-29
4
Related Commands
enable (4-20)
authentication enable (4-71)
IP Filter Commands
management
This command specifies the client IP addresses that are allowed management
access to the switch through various protocols. Use the
no form to restore the
default setting.
Syntax
[ no ] management { all-client | http-client | snmp-client | telnet-client }
start-address [ end-address ]
• all-client - Adds IP address(es) to the SNMP, web and Telnet groups.
• http-client - Adds IP address(es) to the web group.
• snmp-client - Adds IP address(es) to the SNMP group.
• telnet-client - Adds IP address(es) to the Telnet group.
• start-address - A single IP address, or the starting address of a range.
• end-address - The end address of a range.
Default Setting
All addresses
Command Mode
Global Configuration
Command Usage
• If anyone tries to access a management interface on the switch from an invalid
address, the switch will reject the connection, enter an event message in the
system log, and send a trap message to the trap manager.
• IP address can be configured for SNMP, web and Telnet access respectively.
Each of these groups can include up to five different sets of addresses, either
individual addresses or address ranges.
• When entering addresses for the same group (i.e., SNMP, web or Telnet), the
switch will not accept overlapping address ranges. When entering addresses
for different groups, the switch will accept overlapping address ranges.
• You cannot delete an individual address from a specified range. You must
delete the entire range, and reenter the addresses.
Table 4-11 IP Filter Commands
Command Function Mode Page
management Configures IP addresses that are allowed management access GC 4-29
show management Displays the switch to be monitored or configured from a browser PE 4-30