Edge-Core ES3628C, Management Manual, Page: 555 / 674

Multicast Filtering Commands
4-229
4
The following example enables IGMP snooping.
ip igmp snooping vlan static
This command adds a port to a multicast group. Use the no form to remove the port.
Syntax
[ no ] ip igmp snooping vlan vlan-id static ip-address interface
• vlan-id - VLAN ID (Range: 1-4094)
• ip-address - IP address for multicast group
• interface
• ethernet unit / port
- unit - Stack unit
61
. (Range: 1-1)
- port - Port number. (Range: 1-28)
• port-channel channel-id (Range: 1-12)
Default Setting
None
Command Mode
Global Configuration
Example
The following shows how to statically configure a multicast group on a port:
ip igmp snooping version
This command configures the IGMP snooping version. Use the no form to restore
the default.
Syntax
ip igmp snooping version { 1 | 2 }
no ip igmp snooping version
• 1 - IGMP Version 1
• 2 - IGMP Version 2
Default Setting
IGMP Version 2
Command Mode
Global Configuration
Console(config)#ip igmp snooping
Console(config)#
61. Stacking is not supported in the current firmware.
Console(config)#ip igmp snooping vlan 1 static 224.0.0.12 ethernet 1/5
Console(config)#