33
Chapter 5. Safety instructions
EN
5.2. Accessories
Check the following is present inside the packaging:
MX 2
8) Pouch support
8.1) Corner to position pouches
9) Pouches for freezing, cooking and storage
(N. 15 20x30 cm + N. 15 25x35 cm)
10) Power cable
11) Pump filter
(to be fitted before use. See attached
instructions)
12) Chute for draining used pump oil
13) Pump oil filter mounting spanner
14) Hose kit + fittings for external vacuum.
Allows you to connect the equipment to the
container and/or bottle that you want to
vacuum-pack
15) Vacuum bottle cap.
Allows vacuum packing of bottled liquids
MX 4
8) Table
16) Fitting for external vacuum
17) 2.5 mm Allen key
5.3. Environmental conditions
Lift the machine and place it on the working surface. Make sure the machine is placed in a proper environment without
any inflammable and explosive materials or gas. The machine may only be installed on smooth, flat non-inflammable
surfaces.
Working environmental conditions:
Temperature from + 5°C to + 40°C.
Relative humidity from 30% to 90%, without condensation.
The lighting of the operation room shall comply with the laws in force in the country where the machine is installed.
However, it shall be uniform and provide for good visibility in order to safeguard the operator’s safety and health.
MACHINE SAFETY FACTOR = IP20
THE AERIAL NOISE MADE BY THE MACHINE IS LOWER THAN 70 dB(A)
5.4. Intended use
MX 2
: Household and commercial use
MX 4
: Commercial use
Both models cannot be used in a garage.
33
Chapter 5. Safety instructions
EN
5.2. Accessories
Check the following is present inside the packaging:
MX 2
8) Pouch support
8.1) Corner to position pouches
9) Pouches for freezing, cooking and storage
(N. 15 20x30 cm + N. 15 25x35 cm)
10) Power cable
11) Pump filter
(to be fitted before use. See attached
instructions)
12) Chute for draining used pump oil
13) Pump oil filter mounting spanner
14) Hose kit + fittings for external vacuum.
Allows you to connect the equipment to the
container and/or bottle that you want to
vacuum-pack
15) Vacuum bottle cap.
Allows vacuum packing of bottled liquids
MX 4
8) Table
16) Fitting for external vacuum
17) 2.5 mm Allen key
5.3. Environmental conditions
Lift the machine and place it on the working surface. Make sure the machine is placed in a proper environment without
any inflammable and explosive materials or gas. The machine may only be installed on smooth, flat non-inflammable
surfaces.
Working environmental conditions:
Temperature from + 5°C to + 40°C.
Relative humidity from 30% to 90%, without condensation.
The lighting of the operation room shall comply with the laws in force in the country where the machine is installed.
However, it shall be uniform and provide for good visibility in order to safeguard the operator’s safety and health.
MACHINE SAFETY FACTOR = IP20
THE AERIAL NOISE MADE BY THE MACHINE IS LOWER THAN 70 dB(A)
5.4. Intended use
MX 2
: Household and commercial use
MX 4
: Commercial use
Both models cannot be used in a garage.
7/7
34
Chapter 5. Safety instructions
EN
5.5. Electrical connection
Risk of fire and electric shock.
All the electrical connections must be made by a qualified electrician.
The appliance must be earthed.
Do not use multi-plug adapters or extension cables.
Connect the mains plug to the mains socket only once installation has been completed.
Do not connect the mains plug if the mains socket is loose.
Do not pull the mains cable to disconnect the appliance. Pull only the mains plug.
Make sure that all the electrical data shown on the data plate correspond to those of the system.
Otherwise, contact an electrician.
Note: when contacting the Manufacturer, always indicate the model and the serial number
specified on the plate on the rear part of the machine.
The power line must be protected with a type A residual current device with rated residual current equal to
“IΔn”, 30 mA.
As a result, the maximum resistance of the earth electrode must correspond to the values indicated in the
following table.
IΔn
Maximum resistance of the earth electrode
(50 V)
(25 V)
3 A
16 Ω
8 Ω
1 A
50 Ω
25 Ω
500 mA
100 Ω
50 Ω
300 mA
166 Ω
83 Ω
30 mA
1666 Ω
833 Ω
5.6. Use
Risk of injury, burns, electric shock or explosion.
Do not touch the sealing bar after use. Residual heat can cause burns.
Do not modify the specifications of this appliance.
Do not leave the appliance unattended during operation.
Turn the appliance off after use.
Do not use the appliance with wet hands or when it could come into contact with water.
Do not use the appliance as a work surface or as a support surface.
Do not place or keep flammable liquids, materials or objects on the appliance, or inside or close to it.
Do not proceed with packaging if the cover (6) has cracks or is broken.
You may damage the appliance.
Pay attention when you remove or insert the accessories.
Do not force the cover (6) open during the work cycle.
Do not force the cover (6) open during the work cycle in the case of a power cut.
Do not place any weight on the cover (6).
Prevent any object from falling on the cover (6)! This can compromise the integrity, causing cracks or damage.
