21
1.-INSTALLATION
Positioning and levelling
The positioning and electrical and gas installation should always be carried out by an AUTHORISED
TECHNICIAN, observing the standards of each country.
It is advisable to install an extraction hood for the optimum operation of the appliance.
Place the appliance in a well-ventilated place.
Level and adjust the height of the appliance. H min=30mm (Fig. 2)
Electrical connection
An AUTHORISED TECHNICIAN should always carry out the appliance’s electrical connection.
The legal standards in force in each country on connections to the mains should be taken into
account.
Check that the mains voltage corresponds to that indicated on the nameplate.
Use cable sleeves made out of polychloroprene or other similar materials (H05RN-F), for the
connection.
A switch device should be installed next to the appliance for all the phases, with a gap of a
minimum of 3 mm between contacts. This switch will be equipped with fuses.
It is obligatory to earth the appliance. The manufacturer takes no responsibility if this requirement
is not fulfilled.
Electrical connection
An AUTHORISED TECHNICIAN should always carry out the appliance’s electrical connection.
The legal standards in force in each country on connections to the mains should be taken into
account.
Check that the mains voltage corresponds to that indicated on the nameplate.
Use cable sleeves made out of polychloroprene or other similar materials (H05RN-F), for the
connection.
A switch device should be installed next to the appliance for all the phases, with a gap of a
minimum of 3 mm between contacts. This switch will be equipped with fuses.
It is obligatory to earth the appliance. The manufacturer takes no responsibility if this requirement
is not fulfilled.
The section of cable sleeve and the rating of the fuses to be installed in the power switch are
indicated in diagram no. 2.
VERY IMPORTANT
: Before putting the switchboard top on, fasten the electric supply cable tightly
to the stuffing box.
When several appliances are installed in series, they should be earthed to each other using the
point assigned for this purpose, located in the appliance's base, at the back.
2.-USE
Turning the appliance on
Turning the table plates on
a) Press the power switch situated on the outside of the appliance.
Summary of Contents for CV-400
Page 3: ...2 Fig 2 Fig 3...
