3.1.2.5 Key tones
You can deactivate the alarm center key tones by entering
1234
(or your personal code) followed by
8.
To reactivate the beeps, simply repeat the same operation.
3.2 Installation and programming of the accessories
3.2.1 Programming the accessories
IMPORTANT:
Accessories have a booting delay, it is therefore imperative to insert batteries into
each accessory 5 to 10 minutes before you start programming.
TIP:
For an easier learning, set all the elements on a table in front of you, prior to the installation in
the selected location.
Before the alarm center can communicate with the accessories, a learning procedure should be
executed.
To learn a new accessory:
-
On the alarm center enter
1234
(or your personal code) followed by
the red and yellow
LEDs will flash
-
Press for 3 seconds the deactivation button of the remote control or learning button of the
accessory you wish to add (see drawing below).While receiving the signal, the red and
yellow LEDs will stay on and a beep will sound to confirm
3.2.2 Deleting the accessories
The alarm center can not erase each accessory independently. If you want to delete an accessory,
you should delete all elements. Which means, after resetting the memory, you will have to reprogram
each accessory.
To delete all the accessories:
-
On the alarm center enter
1234
(or your personal code) followed by
#, a beep will sound
and the red and yellow LEDs will light up
-
Re-enter
1234
(or your personal code) followed by
#,
a beep will sound to confirm the
accessories have been deleted.
The alarm center exits the accessory deleting mode automatically after 15 seconds or by entering
1234
(or your personal code) followed by
4
5
A PROBLEM?
Do not hesitate to call us on our hotline on 0825 560 650.
Our technicians will be happy to help you to refine your installation.
