3. Installation and programming of the system
3.1 Installation and programming of the
alarm center
3.1.1 Installing the alarm center
Prepare the installation of the alarm system by inserting two screws into the
wall 50 mm apart horizontally and at sufficiently high above the ground.
- Open the battery compartment on the back of the HA33S.
- Insert the 4 alkaline batteries LR06 "AA" type
- Close the battery compartment on the back of the HA33S
- Mount the alarm center in the selected place
Your alarm system is now ready to be programmed
LOW BATTERY:
When the batteries in the alarm center must be changed, the
alarm center will beep every 30 seconds and the yellow light
will flash.
ALARM CENTER LOCATION
Check and pay attention to the following points before choosing a location and installing the alarm
center:
-
Make sure to install the alarm center in an area where an intruder may not reach without
passing in front of a magnetic sensor, or an infrared detector.
-
The alarm center must be mounted near a telephone plug or a BOX.
-
The alarm center should not be visible from the outside.
-
To avoid the risk of electromagnetic interference, do not place the alarm center within a
meter of large metal objects or appliances, refrigerators, washing machines, high voltage
wires, electrical panel, etc.
-
To ensure the best possible reception, the mounting height should be greater than or
equal to 1.5 m from the ground level.
3.1.2 Programming the alarm center
3.1.2.1 Setting the PIN
A personal code should first be saved using the buttons on the alarm center. This code is to be
chosen by you, it will be used to activate or deactivate the alarm. Change the code as follows:
-
First enter the factory code
1234
-
Then press the
No. 6
button,
a beep will sound and the red and yellow LEDs will light up.
-
Enter your 4-digit personal code
-
Press the No. 6 button to confirm the code change, a beep will sound that will confirm that
your code has been changed.
To change your code again, repeat the previous steps but replace the factory code by your code.
3
A PROBLEM?
Do not hesitate to call us on our hotline on 0825 560 650.
Our technicians will be happy to help you to refine your installation.
