•
NOTE
:
To further upgrade your suspension, use other Edelbrock suspension, components, such as: springs,
shocks, trailing arms, panhard rod, strut tower brace, and sub-frame connectors.
6.
Drill or grind off rivet heads (Figure 2) and
disassemble bracket. Remove O.E.M.
bushing from bracket assembly.
7.
Install inner bracket onto transmission.
8.
Place the new torque arm under vehicle
and onto rear end with factory bolts and
washers. Use supplied washers between
rear end housing and torque arm bracket,
only if needed. Use thread-locking
compound. Leave bolt loose at this time.
9.
Grease inside of new polyurethane bushing
with supplied grease, and install onto
torque arm with part number on bushing
facing rear of vehicle. Position in inner
bracket.
10. Install outer bracket and tighten at this
time.
11. Torque rear bolts to 97 ft./lbs.
12. After driving approximately 10 miles,
re-torque all bolts and check on regular
basis.
Inner/Outer Bracket
Fig. 2
Outer Bracket
Inner Bracket
Edelbrock Corporation, 2700 California Street, Torrance, California 90503
Toll-Free Tech Line (800) 416-8628
Tech E-mail: [email protected]
2001 Edelbrock Corporation Revised 7/01 (R&D)
Rivet
Rivet
Rivet
Rivet
