Versatrax 100™
Document: UMDT013103.docm
Revision: A10
Created by: KJB
Date: 26 Sep 2019
3070984-A10
Source Location: C:\ePDM\ISLEng\products\dt-versatrax100mkii\manuals\UMDT013103.docm
Page 34 of 41
Us
er
M
an
u
al
Rear Camera (Optional)
An optional rear camera may be installed on the in-line vehicle.
No camera:
Install the blank plate as shown below. The wired camera connector will be stowed in the
counter-bored hole under the lid.
Rear camera:
Remove the blank plate. Plug the camera connector wiring into the rear camera module.
Screw the module in place, ensuring the O-ring is clean and fully seated in its groove. Camera modules
come aligned from the factory. If further adjustment is required to level the image, slightly loosen the two
screws holding on the camera lens and rotate until the image is level.
FIGURE 27: OPTIONAL REAR CAMERA