Minitrac™
Document: UMDC013503.docm
Revision: A13
Created by: JSS
Date: 17 Nov 2019
3072929-A13
Source Location: C:\ePDM\ISLEng\products\dc-minitracs8000\manuals\UMDC013503.docm
Page 17 of 26
User Ma
nual
Belt Installation
Track with Spring Tensioner
To remove the belt, do the following as shown below:
1. Install the spring compression screws (M8 x 50 SHCS) at the front of the track and completely
compress the tension springs as illustrated in the figures below. Note that the spring
compression screws should be lubricated with never-seize or light grease before use.
2. With the tension springs compressed, the belt is free to move by simply sliding it off the drive
(rear) wheel and over either side plate of the Minitrac
™, as below.
3. To install a new belt, place it on the idler wheel up front, then slide the belt over one of the side
plates and onto the drive wheel. When the tension screws are backed off again and removed,
the springs automatically tension the belt.
STEP 1
STEP 2
STEP 3
