Chapter 2 — The Quad Tc/mV Amp
9
The Quad Tc/mV Amp Self Test
After you have installed the software, connected the
e-corder
to a
computer as described in your
e-corder Manual
, and connected the
Quad Tc/mV Amp as described above, a quick check can be
performed:
• Turn on the
e-corder
and check that it performs its normal
diagnostic tests, as described in the
e-corder Manual
• Once the
e-corder
is ready, open Chart software.
• During initialization, you should see these indicators flash briefly
and then remain lit — the Quad Tc/mV Amp is ready for use.
If the indicators do not light, check your cable connections and repeat
the procedure. If this does not solve the problem, contact your eDAQ
distributor.
Using Chart software
Setting up the Quad Tc/mV Amp
When the Quad pH/mV Amp is connected to an
e-corder
input and
successfully installed, the Quad Thermocouple… menu command
appears in the Chart software Channel Function pop-up menu,
Figure
2–6
.
Choosing the Quad Thermocouple… menu command will access the
Quad Thermocouple dialog box (which replaces the normal
e-corder
Figure 2–6
Accessing the Quad
Tc/mV Amp controls
Summary of Contents for Quad Tc/mV
Page 4: ...iv Quad Tc mV Amp ...
Page 8: ...4 Quad pH mV Amp ...
Page 18: ...14 Quad pH mV Amp ...
Page 22: ...18 Quad Tc mV Amp ...
