56
Midi Port Address
Default:330
Midi Port IRQ
Default: 10
This item lets you disable the built-in MIDI port, or enable it by
assigning an I/O address. If you enable the MIDI port, use the following
item
Midi Port IRQ
to assign an Interrupt Request line to the port.
After you have made your changes in the Super I/O Device screen,
press <Esc> to return to the Advanced Chipset Features screen.
Init Display First
Default: PCI Slot
Use this item to define if your graphics adapter is installed in one of the
PCI slots or select Onboard if you have a graphics system integrated on
the mainboard.
OnChip USB Controller
Default: All Enabled
Use this item to enable or disable one or all of the USB ports or USB
headers that are integrated on this board.
USB Keyboard Support
Default: Disabled
Enable this item if you plan to use a keyboard connected through the
USB port in a legacy operating system (such as DOS) that does not
support Plug and Play.
IDE HDD Block Mode
Default: Enabled
Enable this field if your IDE hard drive supports block mode. Block
mode enables BIOS to automatically detect the optimal number of block
read and writes per sector that the drive can support and can improve
the speed of access to IDE devices.
PWRON After PWR-Fail
Default: Off
Set this item to On to enable your computer to automatically restart
after a power failure.
If you make any changes to the onboard FDD controller, serial
ports or parallel ports in this setup, save the changes and turn
off the system. After powering up the system, ensure that the
changes have taken effect.