ECS GF7050VT-M, Manual

Page: 18 / 64

12
Installing the Motherboard
Installing Memory Modules
This motherboard accommodates two 240-pin unbuffered DIMMs and supports DDR2
667/533 (over spec up to 800) DD R2 SDRAM.
DDR2 SDRAM memory module table
Memory module Memory Bus
DDR2 533 266 MHz
DDR 2 667 333 MHz
DDR 2 800 400 MHz
You must install at least one module in any of the two slots. Each module can be
installed with 2 GB of memory; the total memory capacity is 4 GB.
Installation Procedure
Refer to the following to install the memory modules.
1 This motherboard supports unbuffered DDR2 SDRAM only.
2 Push the latches on each side of the DIMM slot down.
3 Align the memory module with the slot. The DIMM slots are keyed with
notches and the DIMMs are keyed with cutouts so that they can only be
installed correctly.
4 Check that the cutouts on the DIMM module edge connector match the
notches in the DIMM slot.
5 Install the DIMM module into the slot and press it firmly down until it
seats correctly. The slot latches are levered upwards and latch on to
the edges of the DIMM.
6 Install any remaining DIMM modules.
Do not remove any memory module from its antistatic packaging until you
are ready to install it on the motherboard. Handle the modules only by
their edges. Do not touch the components or metal parts. Always wear a
grounding strap when you handle the modules.