GREEN LED
AMBER LED
RED LED
ECOWATER
S Y S T E
M S
Remote Monitor, Features/Options
22
Remote Monitor, Features and Options
This EcoWater unit comes with a Remote Monitor which can conve-
niently be placed in your home for viewing of your conditioners’status.
During normal operation, the green LED will flash at intervals of 5 sec-
onds. If the unit requires salt, the amber LED will flash, and if the unit
needs to be checked the red LED will flash. Follow the steps below
to set up the remote monitor.
Test Remote:
Press SELECT/EXIT (
¿
) to enter the Primary Menu.
Move the cursor next to Advanced/Service Menu and press SELECT/
EXIT (
¿
) to enter this Menu. Warning screen will show. Press SE-
LECT/EXIT (
¿
) to continue. Move cursor to Test Remote and press
SELECT/EXIT (
¿
) to enter this screen. The timer will start sending
a signal to the remote every 3 seconds. When the remote is receiving
this signal, the LED’s will flash red, amber, green. Now remote can
be placed in a convenient location. If only the red LED starts to flash,
the remote is out of range of signal and needs to be repositioned.
Press SELECT/EXIT (
¿
) to exit to the Primary Menu. Now the unit
should start transmitting a normal signal.
The timer on the EcoWater Systems conditioner will send a signal to the remote monitor every minute. The
remote monitor will listen for a signal every 10 minutes. Any changes in softener status could possibly take
up to 10 minutes before the remote registers the change. If the unit stops sending a signal, the remote will
keep trying to listen for the signal. If after 10 minutes with no signal received, the remote will try 1 minute
later and 2 minutes later to find the signal, gradually increasing the time between, but will keep trying to listen
for the signal up to 2 days. After 20 minutes with no signal received, the remote monitor will turn off the LED’s
to conserve battery life, but will still be active. After 2 days with no signal received, the remote monitor will
shut down untill the reset button is pushed (on back of remote).
The EcoWater Systems remote uses 3 “AA”batteries, which are included on the small parts skin pack. To
check batteries, press reset button on back of remote monitor. If batteries are good, the LED’s on the remote
should scroll red, amber, green. If display is blank, batteries need to be changed.
continued
