16
ECOWATER
S Y S T E
M S
Remote Monitor, Features/Options
This EcoWater Systems conditioner comes with a Remote Monitor which
can conveniently be placed in your home for viewing of your conditioners’
status. During normal operation, the green LED will flash at intervals of 5
seconds. If the unit requires salt, the amber LED will flash, and if the unit
needs to be checked the red LED will flash.
The controller on the EcoWater Systems conditioner will send a signal to the remote monitor every minute.
The remote monitor will listen for a signal every 10 minutes. Any changes in softener status could possibly
take up to 10 minutes before the remote registers the change. If the unit stops sending a signal, the remote
will keep trying to listen for the signal. If after 10 minutes with no signal received, the remote will try 1 minute
later and 2 minutes later to find the signal, gradually increasing the time between, but will keep trying to listen
for the signal for up to two days. After 20 minutes with no signal received, the remote monitor will turn off the
LED’s to conserve battery life, but will still be active. After two days with no signal received, the remote monitor
will shut down untill the reset button is pushed (on back of remote).
The EcoWater Systems remote uses 3 “AAA” batteries, which are included. To check batteries, press reset
button on back of remote monitor. If batteries are good, the LED’s on the remote should scroll green, amber,
red. If LED’s do not light, batteries need to be changed.
If there is another EcoWater Systems conditioner within range of the remote, it may cause a conflict with the
channel that the remote monitor is receiving. If the remote monitor displays the wrong message (example:
low salt when salt is above warning level) this is an indication that the remote monitor is receiving a different
signal. Follow the steps below to change the remote channel.
Set Remote Channel:
Enter Advanced/Service Menu. Move cursor next
to Set Remote Channel and press SELECT/EXIT (
↵
). Default is random
from 1 to 16. Press (
↑
) or (
↓
) to select new channel. Press SELECT/EXIT
(
↵
) to exit to the Primary Menu and press reset button on back of remote
monitor.
NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two condi-
tions: (1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. Changes or modifications not expressly
approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note:
ALSO SEE SERVICE INFORMATION, PAGES 17 THROUGH 21.
GREEN LED
AMBER LED
RED LED
