22
23
This manual is the intellectual property of Ecosoft. Copying and reprinting is prohibited. © 2014
ENG
12,5 mm
17 mm
REVERSE OSMOSIS SYSTEM INSTALLER AND USER GUIDE
4.
STEPS FOR INSTALLING REVERSE OSMOSIS SYSTEM
12.
Open the water tap
5
and let through the first two pre-filters with cartridges 5-7 liters of water to wash off the coal
dust that may appear in cartridges during shipping.
CAUTION! This water will pour through the tube disconnected from auto shut-off valve, prepare a vessel to
collect it.
13.
Insert the cartridge into the third sump along water flow direction and attach the sump back again. Let through at
least 4 liters of water to wash off the coal dust. Close the feed valve
5
and connect the free end of the tube back to
the auto shut-off valve.
14.
Install the membrane
11
into the membrane housing.
CAUTION! Cut the plastic bag to install the reverse osmosis
membrane. Install the membrane without first unpacking it by
pushing it into the housing directly from the bag. Avoid touching the
membrane and only hold it covered with the bag.
15.
Leave the feed valve
5
and purified water faucet 3 open for 30 minutes. Then open the tank valve
6
. Close the faucet 3
and carefully check all connections for leaks.
CAUTION! The first week after installation, check the system daily for leaks, do it periodically in the future. If you are
leaving for a long time such as for a business trip or vacation, shut off the water supply.
16.
After the water tank is filled (you will hear the water stop flowing) drain all water from the tank by opening the faucet
3
.
After the tank has been emptied, close the faucet
3
so that the tank starts re-filling. Depending on the pressure in your
water mains, it may take 1.5 to 3 hours. After the tank is filled for the second time, you can use purified water.
A
A (1 : 1)
A
A (1 : 1)
Summary of Contents for RO 5-100
Page 2: ...2...
