Operation
3
1. If desired, mount the Base in an appropropriate location (see page 4).
2. Adjust the wire stand (see page 4).
3. Plug in either the 12VDC car adapter or the AC adapter (see page 5).
4. Snap the unit and wire stand into the base.
5. The Fresh Air To Go unit will come on when either of the FAN buttons
on the control pad are pressed.
6. Adjust the fan speed by pressing the FAN UP and FAN DOWN
buttons. The unit may also be turned off by pressing either the FAN
UP when the fan is set on HIGH, or FAN DOWN when the fan is set
on LOW. When the unit is off, all the LED lights will also be off
7. Set the purifi er by pressing the PURIFIER UP and PURIFIER
DOWN buttons. See the Purifi er Settings chart (page 4) for proper
adjustments. When the purifi er is set to off, the PURIFER LEDs will
also be off, the FAN LED(s) will remain on.
Purifi er Settings & Coverage
Low: compact car, pick up, small offi ce
Med: mid to full size car, SUV, RV, etc.
High: min. 500 ft
2
(46m
2
) - large RV or unoccupied car or pickup
OFF: Purifi er off, ionization & fan continue operating
Mounting the Base
The base for the Fresh Air To Go can be mounted using the
included suction cups, velcro, or screws, depending on preference.
When using suction cups or velcro, be sure the surface is smooth
and clean. Dirt, grease, protectants, and other substances will
affect performance and holding ability.
• Apply clear urethane feet
before mounting base, then...
• peel and stick one part of the
velcro to the base, then
• attach the other to a clean,
dry surface, or...
• attach suction cups by pressing
and twisting into the base, or...
• screws may be used for extra
security and where the other
methods are not appropriate.
