EcoMaster DELUXE EVO3, Installation And User Manual

Page: 8 / 20

7
®
C
NEBO
C
NEBO
1
To seal the sink flange use the supplied thin
rubber gasket (Fig. 1a).
In case you need to achieve a better fit of the
sink flange with the bottom of the sink, apply
only the plumbing putty instead of the rubber
gasket (Fig. 1b).
1. Sink flange with the rubber gasket
or plumbing putty applied and placed into
the sink opening (Fig. 2).
2. Pod dřezem nasuňte na hrdlo tlumící
gumový kroužek (obr. 3) lesklou stranou
(s kluznou fólií) směrem dolů.
3. Install the metal support washer.
(Fig. 3).
4. Install the top clamping bayonet and
the three bolt screws (Fig. 3).
5. Install the self-locking circlip (Fig. 4a) into
the groove of the sink flange by pressing,
so that the spring „clicks“(Fig. 4b).
6. Tighten all three screws one at a time.
(Fig. 4c). At the same time, pay attention
to the centering of the neck from the upper
(visible) side of the sink.
To install the self-locking circlip
- spring (Fig. 4) the use of both hands
is required. Ask another person to hold
(load) the sink flange in the sink during
installation of the circlip ring or use a
bucket of water from above to weigh it
down.
Installation of the sink flange
into the sink
For a more comfortable use instead of using
a standard rocker wall switch you can use an
air button switch see chapter „ Waste disposer
control options“ installed in the sink (Fig. 5a).
To insert the air button switch into the sink, you
can use the hole after removing the eccentric
control of the original outlet (if the sink has
the hole for this system blocked). If the hole
is missing, it will be necessary to created by
drilling either directly into the sink or worktop
area (Fig. 5b).
The hole is made with a suitable tool
Ø33–35 mm depending on the drilled material.
Diamond crown for granite, stone, marble,
ceramics. Drill and stripping tool for stainless
steel. Reamer for wooden worktop.
Insert the air switch button into the hole and
from below tighten the nut (Fig. 5c). Then
attach the hose to the outlet of the tube, see
chapter „Connecting the tire-button hose
to the crusher“ .
„Air switch tube connection to waste disposer“.
Please note:
Air button switch is included.
8596220001733 (Contact your local dealer).
1a.
1b.
2.
3.
C
NEBO
4a. 4c.
Self-locking circlip
(spring)
C
NEBO
C
NEBO
2
Drilling the hole and assembly of the
air switch button (optional as required)
Creating a hole
for the air switch
5b. 5c.
C
NEBO
The supplied locking screws are intended primarily for fastening the
sink flange in stainless steel sinks. For thicker sinks (granite, ceramic,
concrete) tightened screws may interfere with the installation of the.
In this In this case, use shorter screws.
Air-switch button
5a.
Sink
Locking nut
Gasket
Ø33–35 mm
4b.
Air switch
Air tube
Installing the mounting assembly into the sink
Sink flange
Rubber gasket
(thin)
Plumbing putty
Dampening ring
(washer)
Clamping bayonet
Underside of the sink
Sink flange
Metal support washer