ecom-DP3
Page 31
Press
<F1>
(Start) prior to going thru the following steps to start the measure-
ment:
- release tubing of the flow probe
- wait for zeroing of pressure sensor
- re-connect tubing of the flow probe
- position flow probe into exhaust gas pipe (observe mark for flow direction)
- switch off burner and simultaneously press
<F1>
or:
- press
<F2>
to activate timer (5 sec.) and switch off burner by beep
- after approx. 30 sec. the measurement value converted in negative points
is available
An overview of the measurements is available under
„Results“
. Press
<Print>
to
print them out.
Gas loss 2.9 %
Points 2.6
Surf. Lo. 2.29 %
Points 3.4
Vent. lo. 3.11 %
Points 3.0
Heating Check
Quit with:
Gas losses
Surface losses
Ventilation losses
Results
Cancel
Heating Check
Select:
Summary of Contents for DP3
Page 1: ...Operating Instructions ...
