3
1. Unpack the packing box and take the base & the pole assembly out of the box,
and then loosen the fastening bolt from the bottom of the pole assembly .
(See Fig.1)
2. Put the pole assembly into the Round Base and then lock them together by
tightening the fastening bolt . (See Fig.2)
3. Loosen and remove the height adjustment ring from the extension pole and then
adjust the internal pole to desired height . (NOTE: The internal pole is located
inside the extension pole. If you can't find it , you can pull it out from the
extension pole.) (See Fig.3)
4. Loosen the thumb screw on the bottom of the head unit and attach the head unit
to the column , tighten the thumb screw in alignment with the groove on the
internal pole . (See Fig.4)
ROUND BASE AND COLUMN UNIT ASSEMBLY
GUARD & FAN BLADE ASSEMBLY
1. Remove the plastic nut by turning it counterclockwise.
2. Place the rear guard to the head unit make sure the handle is upward.
3. Screw on the plastic nut (clockwise) securing the fan guard on the head unit.
(Step 1,2,3 see Fig. 5)
4. Discard the small plastic sleeve located on the motor shaft.
5. Install the fan blade onto the motor shaft. Make sure the fan blade slot fits into the
retaining pin of the motor shaft.
6. Attach the spinner to the motor shaft by turning it counterclockwise to secure the
fan blade. (Step 4,5,6 see Fig. 6)
Annular groove
Trou de fixation
Thumb screw
Loosen
Fig. 1
Fig. 2
Fig. 3
Fig. 4
