6
PRINTED IN CHINA
The fan requires little maintenance. Do not try to fix it by yourself. Refer it to
qualified service personnel if service is needed.
1. Before cleaning and assembling, do not plug the pins into the socket.
2. To ensure adequate air circulation to the motor. Keep vents at the rear of the
motor housing from dust, fluff and etc. A vacuum cleaner can not be used to
clean these vents before unplug. Do not disassemble the fan remove fluff.
3. Please wipe the exterior parts with a soft cloth soaking a mild detergent.
Do not use any abrasive detergent or solvents to avoid scratching the sufrace.
Do not use of the following as a cleaner: gasoline, thinner, bending.
4. Do not allow water or any other liquid into the motor housing or interior parts.
MAINTENANCE INSTRUCTIONS
CLEANING
1. Be sure to unplug the power cord from the outlet before cleaning.
2. Plastic parts should be cleaned with mild soap and damp cloth or sponge.
Thoroughly remove soap film with clean water.
3. Be sure not to get water or other liquid enter the inside of the motor.
4.
Dry all parts completely before reassembling and reconnecting to power
source.
(4) BATTERY WARNING AS BELOW
Do not
dispose of batteries in fire, batteries may
explode or leak.
Do not
mix old and new batteries.
Do not
mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
Pay attention
to poles (+ and -) of the batteries.
To adjust the air flow upward or downward, push the
grilles lightly to the desired direction.
III. TILT ADJUSTMENT
Loosen the height adjustment ring and adjust the internal pole to the desired
height. Tighten the ring when desired height is achieved (See Fig. 3)
IV. HEIGHT ADJUSTMENT
To make the fan oscillate , press the “ ” OSC key on the control panel, and to
stop the fan from oscillating in the position desired , press this key again.
V. OSCILLATION CONTROL
Fig.10
