ECOFOREST CANTINA 24, Installation And Maintenance Manual

Page: 47 / 136

46
6.13. If when the reducer motor rotates makes a noisy is due to a lack of lubrication- you have to lubricate only the
auger screen,
not the reducer motor , see point 5.16 .
PELLETS FALL BUT THE BOILER DOES NOT TURN ON:
6.14. Make sure the glass door is well closed.
6.15. Check that the resistance is properly placed. That is, the resistance support tube coincides with the largest
centre hole in the burn pot. Similarly, the resistance support tube must abut the burn pot.
Drawing 29
6.16. Pay special attention to the cleaning of the boiler as excess of dust may prevent the boiler from starting on.
THE START-UP RESISTANCE DOES NOT WORK:
6.17. Make sure the resistance heats, by moving your finger close to
(but not touching)
the hole that focuses heat
from the resistance (largest hole in the centre).
THE GAS OUTLET EXTRACTOR DOES NOT WORK OR DOES NOT WORK CORRECTLY:
6.18
.
Make sure the motor rotates properly by rotating it with your hand (the stove should be disconnected to do
so).
6.19
.
Check that power reaches the motor, by turning the boiler on.
6.20. Also check the exhaust connection strip and the C.P.U.
THE RECIRCULATION PUMP DOES NOT ROTATE:
6.21. If the boiler accumulates heat and the pump does not move water towards the installation, contact your
dealer.
THE BOILER TURNS OFF:
6.22. There might be no pellets in the boiler.
q
Burn pot.
w
Burn pot support.
e
Resistance air inlet.
r
Resistance drive.
t
Start-up resistance.
y
Resistance tube support.
u
Screw of resistance.
i
Resistance support guide.
o
Resistance support tube, badly fixed.
a
Resistance support tube, badly fixed.
s
Start-up resistance, badly fixed.
d
Resistance support tube; badly fixed.