ECOFOREST CANTINA 24, Installation And Maintenance Manual

Page: 44 / 136

43
Once you clean the walls of the stove, you must be sure that the cleaning outlet is securely closed, since the
proper operation of the stove depends on this cleaning.
5.9.
Cleaning of the gas outlet circuit. Always with the boiler disconnected
. (Very important).
For an optimal cleaning of the extractor’s collector, it is recommended to dismantle the extractor itself in order
to have full access to this zone for a better cleaning. Once the extractor is dismantled, clean it with a dry brush
and be careful with the turbine and structure.
When reassembling the exhaust it is
COMPULSORY to replace the exhaust joint with a new one as you run the
risk of gas entering in our home.
q
Gas outlet extractor.
w
Ceramic fiber joint (replace).
Drawing 22
5.10.
Dismantling and cleaning of gas outlet pipes.
When mounting the gas outlet pipeline, make sure it is well assembled, preferably sealed with silicone. If the
pipe has sealing joints, you must verify its good condition and replace it if necessary.
5.11. Lubrication of the screw and spring of the gas security valve. It is placed in the right side of the boiler, just
above the cleaning outlet.
q
Lubrication point.
Drawing 23
5.12. Empty the hopper to take remaining pellets out to avoid pellets absorb humidity.
5.13.
Review the fireplace door joints.
Review in detail any imperfections which may cause an air inlet. Replace them if necessary.
5.14. Cleaning of dirt which may be accumulated on the inside of the boiler (lower part, components, etc.). You can
access to it by the rear of thereof.
5.15.
Cleaning of the pellets drop tube.
Use the brush provided by ECOFOREST to remove the dust until the end of the tube.
q
Cleaning brush.
w
Pipe of pellets fall.
Drawing 24
5.16. Lubrication of the brass tips of the endless shaft’s upper and lower parts with lubricant oil; a small quantity is
enough for all the season. This operation is ONLY recommended in case of noisy.