Installation
Connecting panels together
Magen eco-Spark
®
Installation manual. © 2012, all rights reserved
P a g e
|
23
11
If you wish to dismantle the PPC Set, strongly pull the latch lock upwards while your thumb is holding the
flat part of the latch or use a flat-head screwdriver. Gently insert the flat-head screwdriver under the lock
and gradually pull upwards until it is released from place.
If the latch lock is in good conditions it can be used again. The gasket (O-ring) will be better replaced
anyway.
9
Lock the two halves of the clamp together using the latch (120211P). Do this by sliding the wide end
of the cone shaped latch over the thin end of the PPC assembly. Use Channel lock pliers to tighten
the latch grip by squeezing it with moderate force until you hear a 'click' sound and it seats flush so
it cannot slide out of its position. Move your finger over the wide end of the latch to make sure it is
in fact flat. This will confirm that it is positioned securely.
10
Take the latch lock and tilt it so the lock's gripping teeth are positioned inside the groove of the
latch. Gently press downwards into position until you hear a 'click' sound or the latch lock is flat
against the latch.