ECO Plus ELITE Series, Instruction For Installation And Maintenance

Page: 6 / 12

6
THE PUMP MUST BE SUPPORTED BY A BASE. NEVER SUSPEND THE PUMP FROM PIPES.
3. MANAGEMENT
3.1 Storage:
Pump must be stored in a dry, dust free covered area that is free from
vibrations. Keep the pump in its original packaging until time of installation.
3.2 Transport:
Avoid subjecting the pump to needless impacts and collisions.
4. WARNINGS
Do not carry pump by the power cable. Always carry the
pump using the handle.
• Never allow the pump to run dry.
• There is a venting hole to prevent pump from cavitation
when starting the pump. It is normal for a small amount
of water to come out of the pump during operation. (Fig.1).
• The sealing device contains a non-toxic lubricant which
may alter the characteristics of pure water in the unlikely
event of leaks.
5. INSTALLATION
The electrical system must be compliant with local codes .
Screw on the elbow with hosetail fitting provided in the
packaging. For the clear water version there are two
fittings, one 25 mm (0.98”) and one 30 mm (1.18”);
if you want to use a pipe with a larger diameter, change
the elbow coupling. Use a pipe tightening clamp to secure
the pipe to the fitting.
• If the bottom of the trap where the pump is to be placed
is particularly dirty, a raised support should be provided
so as to avoid blocking of the suction grid (Fig.2)
 • Totally immerse the pump in the water.
• Ensure that the minimum dimensions of the trap in
which it is housed are as follows:
Min. base dimensions 18.11”x18.11” (460x460 mm)
Min. height 15.75” (400 mm)
• The dimensions of the trap must always be in relation
to the quantity of water arriving and to the flow of the
pump, so as not to subject the motor to excessive
starts/hour. It is strongly recommended not to
exceed 20 starts/hour.
ALWAYS INSTALL THE PUMP IN VERTICAL POSITION.
(Fig. 2)
(Fig. 1)