JINECI08 RevC 21/05/14
General Guidance
It is important that your stove is correctly installed as
Hunter stoves cannot accept responsibility for any
fault arising through incorrect use or installation.
These instructions cover the basic principles to
ensure satisfactory installation of the stove, although
detail may need slight modification to suit particular
local site conditions.
The installation must comply with current Building
Regulations, national and European standards, Local
Authority byelaws and other specifications or
regulations as they affect the installation of the stove.
The Building Regulations requirements may also be
met by adopting the relevant recommendations in
the current issues of British Standards BS 8303 and BS
EN 15287-1.
C
OMPETENT
P
ERSONS
S
CHEME
Hunter Stoves recommend that this stove is installed
by a member of an accredited competent persons
scheme e.g. HETAS.
If the installer is not a member of a competent
person’s scheme, it is a legal requirement to notify
your local building control body in advance of any
work starting.
CO
A
LARMS
Building regulations require that whenever a
new or replacement fixed solid fuel or
wood/biomass appliance is installed in a
dwelling, a carbon monoxide alarm must be
fitted in the same room as the appliance.
Further guidance on the installation of the
carbon monoxide alarm is available in BS EN
50292:2002 and from the alarm
manufacturer’s instructions.
Provision of an alarm must not be considered a
substitute for either installing the appliance
correctly or ensuring regular servicing and
maintenance of the appliance and chimney
system.
H
EALTH AND
S
AFETY
P
RECAUTIONS
Special care must be taken when installing the stove
such that the requirements of the Health and Safety
at Work Act are met.
H
ANDLING
Adequate facilities must be available for loading,
unloading and site handling.
F
IRE
C
EMENT
Some types of fire cement are caustic and should not
be allowed to come into contact with the skin. In case
of contact, wash immediately with plenty of water.
A
SBESTOS
This stove contains no asbestos. If there is a
possibility of disturbing any asbestos in the course of
installation then please seek specialist guidance and
use appropriate protective equipment.
M
ETAL
P
ARTS
When installing or servicing this stove, care should be
taken to avoid the possibility of personal injury.
M
ODIFICATION
No unauthorized modification of this appliance
should be carried out.
Safety
WARNING –
This appliance will be hot when in
operation and due care should be taken. The supplied
gloves may be used to open the door and operate the
air controls.
A
EROSOLS
Do not use an aerosol spray on or near the stove
when it is alight.
F
IREGUARDS
Always use a fireguard in the presence of children,
the elderly or the infirm. The fireguard should be
manufactured in accordance with BS8423 –
Fireguards for use with solid fuel appliances.
D
O
N
OT
O
VER
-F
IRE
It is possible to fire the stove beyond its design
capacity. This could damage the stove so watch for
signs of over-firing. If any part of the stove starts to
glow red, the stove is in an over-fire situation and the
controls should be adjusted accordingly. Never leave
the stove unattended for long periods without first
adjusting the controls to a safe setting. Careful air
supply control should be exercised at all times.
