3
Selecting the location
Indoor unit
Do not expose the indoor unit to heat or steam.
Select a place where there are no obstacles
in front or around the unit.
Make sure that condensation drainage can
be conveniently routed away.
Do not install near a doorway.
Ensure that the space on the left and right
of the unit is more than 12cm.
Use a stud finder to locate studs to prevent unnecessary damage to the wall.
The indoor unit should be installed on the wall at a height of 2 metres or more from the floor.
The indoor unit should be installed allowing a minimum clearance of 15cm from the ceiling.
Any variations in pipe length may require adjustment to refrigerant charge.
There should not be any direct sunlight. Direct sunlight will fade the plastic cabinet and
affect its appearance. If unavoidable, sunlight prevention should be taken into consideration.
Outdoor unit
Select a location solid enough to bear the weight
and vibration of the unit, where the operation noise
will not be amplified.
Choose a location where the hot air discharge or
noise will not cause annoyance to the neighbours.
Ensure that the clearance around the back of the
unit is at least 30cm,left side is at least 30cm, the
front of the unit is at least 200cm and the connection
side (right side) is at least 60cm.
There must be sufficient spaces for carrying the unit into and out of the site.
The site must be free from the possibility of flammable gas leakage in a nearby place.
Avoid places near a bedroom and the like, so that the noise will not be an annoyance.
Ensure any local authority permission is sought where applicable.
Do not place animals and plants in the path of the air inlet or outlet.
Install units, power cords and cables at least 3 meter away from television and radio sets.
This is to prevent interference to images and sounds.
In coastal areas or places with salty atmosphere of sulfate gas, corrosion may shorten
the life of the air conditioner.
If the outdoor unit is installed on a roof structure, be sure to level the unit.
Ensure that the unit is installed in an accessible location to enable servicing and repair.
Since drain flows out of the outdoor unit, do not place anything under the unit which must
be kept away from moisture.
When operating the air conditioner in a low outdoor ambient temperature, be sure to
follow the following instructions:-
1) Install the suction side of the unit facing the wall to prevent exposure to wind.
2) It is recommended to install a baffle plate on the air discharge side of the outdoor unit.
3)Select an installation site where the snow will not affect the unit such as at a high
enough level to avoid snow burying the unit.
INSTALLATION INSTRUCTIONS
Fig.1
Fig.2
Screwdriver
Electric drill,Hole core drill (
90
mm)
Measuring tape
Tools needed for installation:
Gas-leak detector
Thermometer
More than 2m
More than 15cm
More than 12cm
More than 12cm
More than 30cm
More than
60cm
More than
30cm
More than
200cm
More than 60cm
CAUTION
