ECM LambdaCAN Series, Instruction Manual

Page: 7 / 50

3
Configuring a Module
Normally, you will be configuring a module to be used in stand-alone mode. Stand-alone
mode is used when the modules are connected to a CAN bus that goes directly to a data
acquisition system. In stand-alone mode, a module’s configuration is performed by selecting
one of the tasks in the “Task” field. When a module is connected to a NOx 5210, Lambda
5220, or EGR 5230 display head, it must be in EIB mode. In EIB mode, most of these tasks
are performed using the display head. Appendix B describes how to configure a module to
operate in one mode or the other.
The following assumes that the module is to be used in stand-alone mode. The tasks
available for the LambdaCAN* modules are listed in Table 1.