Eclipse PE300BU, Operator'S Manual

Page: 17 / 44

17
Dust Bag Removal
The machine has two dust bag options. A re-usable cloth
bag and a disposable paper bag. Monitor the dust bag
carefully and empty/change as needed. The dust
collection system will not operate effectively when the
dust bag is full. Under heavy burnishing conditions the
dust bag should be emptied/changed every hour.
1. Turn off the Burnish Motor.
2. Unscrew the knobs holding the dust bag cover to the
shroud.
3. Pull the dust bag off the dust tube.
4. Empty/Change dust bag.
Caster Parking Brake
The two rear casters are equipped with brakes. To set
the brake, push down the “ON” side of the brake lever.
To release the brake push down the “OFF” side of the
brake lever. The caster breaks should only be used as
a parking brake if needed. Before moving the machine
make sure both breaks are released.
Pad Pressure Adjustment
The pad pressure is set at the factory for optimal burnish
performance in most conditions. If the pad pressure
needs to be adjusted, follow the procedure outlined
below.
NOTE: Pad pressure adjustments should only be
performed by a qualified technician.
1. Turn burnish switch off.
2. Remove back panel.
3. Adjust ball end to increase or decrease pad pressure
as shown in diagram.
Post Operation Checklist
Turn the machine OFF and perform the following
checks:
l
Check for wire, string, or twine wrapped around the
burnish pad.
l
Check for frayed wires or damage.
l
Empty the dust collection bag.
l
Inspect batteries.
l
Plug in on-board battery charger.
RF044900 051112
Increase Pad
Pressure
Decrease Pad
Pressure