Eclipse ecoflex Eco-100 PRO, Manual, Page: 8 / 23

Page 8 of 23
BEFORE YOU BLAST
Pre-Blast Check
Before each use of the Abrasive Blaster, it must be checked to ensure it is in a safe condition to be
used. Closely examine all components of the Abrasive Blaster for signs of excessive wear, worn out
seals and hoses, or damaged components. If any component of the Abrasive Blaster is found to be
damaged or worn, it must be replaced before blasting.
WARNING : Never use an Abrasive Blaster if any components are damaged or worn.
Damaged or worn parts must be replaced before use.
DANGER : Never reach into the Pop-up opening while filling the Abrasive Blaster. It can
close without warning causing severe injury or death.
WARNING : ECO-Flex® ECO-100 Abrasive Blasters may not be used with abrasives
containing silica.
Never use abrasives containing silica.
WARNING : Always use safety devices like clips and whip-checks (safety cables) at hose
connections.
Connecting Hoses
Before connecting hoses to the Abrasive Blaster, make sure the compressed air supply is shut off.
Connect the hose coming from the compressed air supply to the inlet on the Abrasive Blaster and
secure with safety clips. Connect the blast hose to the coupling by the Metering Valve at the base
of the Abrasive Blaster and secure with safety clips.