USER MANUAL
– EVERLUX
Page
7
de
11
INMANUUIN167 Rev.2019.04.01 / ENG
4.1 REVISION
Once installation is over and before turning the EVERLUX on, please go through the following
check list:
Verify that the electrical network has its grounding connection in perfect conditions and
that it makes perfect contact with the equipment.
Check that the fuse holder has a fuse installed and that it is the correct one (T3AL250V).
Check that the lateral ventilation grid is completely free, without obstruction.
Ensure an adequate air flow.
Verify that there are no water or liquid sources near the equipment that may damage it,
such as gases or flammable emissions in the environment.
All connections shall be made before turning the equipment on.
The EVERLUX shall only be used in places with electrical installations that meet the
national, provincial and local regulations in effect.
If before connecting the EVERLUX any anomaly is detected, please contact the technical service
department of your local distributor or the closest ECLERIS office, prior to its use.
5. OPERATION
– FUNCTIONS
This section thoroughly describes the device functioning.
This system must be used only for medical, paramedical or health professionals.
1) Connect the power supply cable to the equipment and the electrical network.
2) Turn the EVERLUX on by pressing the general on/off switch.
3) Turn the LED system on by turning the light intensity control (dimmer) clockwise.
4) Use this control to regulate the light intensity.
The EVERLUX light source has an over-temperature protection. LED system will turn off if
it reaches a risky operation temperature.
5) Once the procedure is over, turn the EVERLUX off in order to maximize the LED system
lifetime and energy saving.
6) Should you use a video camera (Ecleris PROCAM), connect it to the video input
connector.
7) Connect the video output (rear panel BNC or S-Video connector) to the video input of the
viewing device and turn the EVERLUX on.
8) Select the video input and video Standard in the viewing device.
6. MAINTENANCE
In order to keep an optimum operation of the EVERLUX it is recommended to perform the
following procedures:
Periodic cleaning of all exterior components.
Connections inspection.
Annual technical inspection of the equipment.
