Chapter 3
•
Installing the antenna and radio
1039740-0001 Revision B
29
Installing the antenna reflector
Follow the steps below to attach the antenna reflector to the reflector bracket.
While attaching the reflector bracket, do not place the reflector face down on
a hard surface. The weight of the reflector bracket and any additional pressure
during assembly could bend the reflector.
1.
Line up the holes on the reflector with the holes on the reflector support, as
shown in
2.
Insert six thread cutting screws (
11
32
⁄
-14 × 1.13 inch) into the holes in the
reflector bracket and through the corresponding holes in the reflector, as
shown in
Figure 11: Attaching the antenna reflector
3.
Tighten the screws using a
5
16
⁄
inch wrench.
