UM-ER-EB1000M-1-20210315-US
5.2.2 Wall or Mast Mounting
1. Place the wall mounts in their desired
positions on the device. They can be
placed horizontally or vertically.
2. Use adequate force to drive the
mount bolt in the device notch.
If
using a hammer, please be sure not
to accidently hit and damage the
device casing.
3. Repeat with the other mounts.
Figure 5-III: Wall or mast mounting
TIP
— Attaching wall mounts to a device is irreversible.
6 Replace a Device
To replace a device, all devices in the pertaining network must be reconnected and then
reconfigured with the replacement device, according to the procedure in Section 4.3 above.
7 Update devices
ATTENTION
— New devices require a software update before use. In order to be provided with an update
that you can perform, you must first register. Please visit www.r3.group and download registration form
found on the page ”Downloads”.
!
1. Arrange and connect a PC, the R3 Configuration Server
5
and the EchoRing Ethernet
Bridges
1
to the switch
4
, according to Figure 7-I. Make sure that the internal
ethernet connection of the R3 Configuration Server is connected to the switch and the
USB ethernet adapter
7
of the R3 Configuration Server is connected to the internet.
TIP
— The local setup must be connected to a DHCP-configured gateway route to the internet.
1
1
1
2
2
2
3
3
3
4
5
6
6
6
7
7
Figure 7-I: Set-up for updating
© by R3 – Reliable Real-time Radio
Page 13 of 14
6. Replace a Device
