8
9
email - [email protected]
tel - 866-931-8021
email - [email protected]
tel - 866-931-8021
CAMERA INSTALLATION
STEP 4:
There are two locations you can install your EchoMaster backup camera. We
recommend that it is installed on your license plate, but it can also be installed
on your back windshield if needed.
1. Remove
license plate
MOUNTING THE CAMERA ON YOUR LICENSE PLATE
2. Mount the camera to the
top or bottom of your license
plate
2. Re-mount the license plate
MOUNTING THE CAMERA ON YOUR REAR WINDSHIELD
1. Remove bolts
from camera
mounting
bracket
2. Replace the
license plate
bracket with
the windshield
mount bracket
3. Clean the
window with
water or alcohol
and a lint-free
cloth
4. Remove protective film
from the back of the mount
and press firmly to the
windshield for 30 seconds
If mounting on the bottom of your license plate, rotate the mounting bracket as
shown here:
INSTALLATION WIRING
STEP 5:
NOTE:
The GPS module is mounted on the dashboard, with the front side facing
up. (The front side is the side with the word “GPS”)
1. The 9-pin connector at the mirror is connected to the 9-pin interface of
the power cable.
2. Locate the yellow wire (B+), the red wire (ACC), and the black wire
(GND) connectors in the car’s fuse box.
NOTE:
Before you start wiring in the fuse box, connect the two small fuse tap
adapters to the red line (ACC) and the yellow line (B+) respectively.
1. Open the transparent
plastic sleeve on the
fuse tap adapter
2. Insert (following the
direction of the arrow),
until the red box marks
coincide.
3. Put the long end of
the rubber sleeve into the
short side and make sure
the sleeve is tight.
