16
Installation Guide
16
tel - 1-800-477-2267
email - [email protected]
Illustrations are typical and may not match exact vehicle detail
Step 6
Unsnap the door boot on the door side, and feed the
wire tie through with the camera cable taped to the
end. It is not necessary to remove the boot from the
black snap ring.
Only the door side of the boot needs to be removed.
Step 7
Feed a long wire tie or dash snake tool through the boot
then into the vehicle as shown. Reach in behind the access
panel to guide the wire tie if needed.
The boot does not need to be removed from the vehicle
side.
Once inside the vehicle connect the camera cable to the
power supply and then to the camera extension cable
that was ran during step 8 on page 10. Secure the power
supply and any excess wire using a wire tie.
Cable Routing (continued)
NOTE
Once the cable is routed into the door jamb
reinstall the three Torx T30 screws that hold the
mirror frame on to the vehicle to avoid damage.
FCTP-MB1903
Sprinter Tow Package
Mirror Assembly
Step 1
With the cables routed, you can assemble the mirror caps
with the cameras.
