![background image](http://html1.mh-extra.com/html/echo/srm-410u/srm-410u_operators-manual_4155039010.webp)
10
BLADE
INSTALLATION
WARNING
You must install the U-Handle and all Blade Conversion parts shown in the following instructions before operating
this unit with a metal blade, otherwise serious injury may result.
Install Metal Shield
Tools Required:
8 x 10 mm Open-end Wrench, Screwdriver, 17x19 mm Wrench, Locking Tool
Parts Required:
Metal Shield, Shield Bracket,
3 - 5 x 10 mm screws (metal shield to gear housing).
2 - 5 x 10 mm screws, 2 - 5 mm nuts (bracket to shield).
2 - 5 mm nuts (bracket to gear housing).
A
B
A
SSEMBLY
DRIVE
SHAFT
/
POWER
HEAD
Tools Required:
4 mm Hex Wrench
Parts Required:
Power Head, Drive Shaft Assembly
1. Stand power head upright on a level surface.
2. Loosen the drive shaft clamp bolt (A) at engine drive shaft clamp,
and remove drive shaft locating bolt (B).
3. Remove protective plastic cap from end of drive shaft assembly.
Carefully
fi
t driveshaft assembly to engine making sure that
inner drive shaft engages clutch mount.
4. Turn drive shaft housing until locating hole lines up with locating
hole in clamp and install drive shaft locating bolt (B).
NOTE
Gear housing must be aligned properly with engine. Aligning center
locating hole in driveshaft housing with center drive shaft bolt (B)
provides correct alignment.
5. Tighten drive shaft clamp bolt (A) securely.
WARNING
Never start engine without driveshaft assembly installed.
This could result in serious injury.